Grinding & Classification Circuits

Grinding & Classification Circuits

  • To participate in the 911Metallurgist Forums, be sure to JOIN & LOGIN
  • Use Add New Topic to ask a New Question/Discussion about Grinding.
  • OR Select a Topic that Interests you.
  • Use Add Reply = to Reply/Participate in a Topic/Discussion (most frequent).
    Using Add Reply allows you to Attach Images or PDF files and provide a more complete input.
  • Use Add Comment = to comment on someone else’s Reply in an already active Topic/Discussion.

VSI Crusher Grinding production rate (1 reply and 1 comment)

O
dasun
7 years ago
dasun 7 years ago

My plant has a pulverise machine (3-5t/h). It's like as VSI machine. Are there any methods to select suitable input particle size to increase the percentage of yield without increasing the RPM of rotor? Because, when check the samples of pulverise output, there will be less amount of product (20%). when increasing the RPM powder proportion will increase.

J
Jorge Quintanilla
7 years ago
Jorge Quintanilla 7 years ago
Like
1 like by David

The losses are associated with dry powder that leaves to the environment. The key to better control these losses is moisture. The fine thread of balance. Not so wet as to not spray and / or block equipment, nor so dry to lose valuable product with dry powder. This is achieved with a fine spray of water on the feed belt. The heat inside the equipment produces vapors that decrease the losses in dry powder.

O
dasun
6 years ago

Dear Mr. Jorge.
My plant is fully sealed plant.Samples of dust collectors are regularly checking. So, I haven't notices any large particles in the dust collectors. So, do you have any idea...?

Please join and login to participate and leave a comment.