Conveyor Stacker Controls
Stacker control devices can range from minimal stockpile level sensors to quite complex control systems depending on the desired degree of automation. For the simple fixed stacker, a basic stockpile level sensor to prevent the stockpile from getting too high is often the only stacking control required. This level sensor can be just a simple […]
Zinc Dust Precipitation Tests
The use of zinc dust for precipitating the precious metals from cyanide solutions is well established now in many places, and has many advantages over the shavings method of precipitation. Although much work has been done on methods of testing zinc dust, as yet no absolutely positive test has been devised to determine the value […]
Hoisting Ore in Mining
Auxiliaries Actuated by Oil under 135 lb. Pressure When steam is used by the auxiliaries, which operate brakes, clutches, etc., it constitutes an important percentage of the total power used by the engine. The condensation is great and continuous, and since the controlling valves can have no lap, but must be set “line and line,” […]
Ore Tramming in Mining
The ore deposits of the Warren district, in which the mines of the Copper Queen Consolidated Mining Co. are situated, have been described in a number of technical publications, and will not be discussed here in detail. Certain of their characteristics, however, control methods of underground transportation and hoisting of ore. In the Copper Queen […]
Maintenance Policy & Procedure
Maintenance Policy Area Level 1 (basic) Level 2 (controlling) Level 3 (improving) Level 4 (best) 2.1 MAINTENANCE MANAGEMENT LEADERSHIP 2.1.1 Maintenance Mission No mission Mission developed and understood by management Mission developed and understood by management & supervision Mission developed, understood and articulated by management, supervision, maintenance team personnel & […]
Stamp Mill Cam
The cams at present universally used in stamp mills lift the tappets with an involute form of curve, to which the surface of the tappet is always tangent; moreover, the line of contact between tappet and cam, if produced, would pass through the center of the stem. This is no doubt a desirable feature, but […]
Quicksilver Ore Mining & Reduction Method
The low cost of mining was the principal consideration, since, with mercury’s price per pound, the total gross value of the ore did not exceed too much per ton. Square setting and filling was out of the question, so various attempts with cheap methods were made, among them a shrinkage system. None gave satisfaction on account […]
Sound Steel Ingots
Last year this Institute was good enough to accept some remarks by the writer regarding sound steel, entitled Plant for Hadfield Method of Producing Sound Steel Ingots, being a continuation of a research in which for some time the writer has been engaged, and full particulars of which were submitted in papers entitled A New […]
Rotary Rock Drill
In drilling for water and oil to reasonable depths through the generally soft yielding clay and sand formation of the Coastal Plain of Texas, Louisiana, and Mississippi, the rotating method of drilling was adopted, principally on account of the easy and quick penetration, and the low cost of the drilling plant. In favorable ground, free […]
CWi vs DWi
What is the difference between CWi and DWi: WiC measures fracture strength in coarse rocks, DWi measures matrix competence in medium-size rocks.